Tecnoflon® FOR 7352 Datasheet

Fluoroelastomer

Supplied by Solvay Specialty Polymers

Create your free Prospector account to view this complete product datasheet. A free account includes access to hundreds of thousands of detailed technical datasheets. Create Your Free Account
Product Description
TECNOFLON® FOR 7352 is a medium-low viscosity cure incorporated fluoroelastomer copolymer. TECNOFLON® FOR 7352 is well suited for applications where excellent compression set and superior mold release are required.

Some of the basic properties of Tecnoflon® FOR 7352 are:
  • Very good scorch safety
  • Good mold flow
  • Excellent mold release
  • Lack of mold fouling

TECNOFLON® FOR 7352 can be used for compression and transfer moulding of O-rings, gaskets, and seals. The product can be mixed using typical fluoroelastomers compounding ingredients and mixing can be accomplished with two-roll mills or internal mixers.
The material can be extruded into hoses or profiles and can be calendered to make sheet stocks or belting. Finished goods can be produced by a variety of rubber processing methods.
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
  • North America
 
Features 
  • Copolymer
  • Good Flow
  • Good Mold Release
  • Low Compression Set
  • Medium-low Viscosity
Uses 
  • Belts/Belt Repair
  • Gaskets
  • Hose
  • Profiles
  • Seals
  • Sheet
Appearance 
  • Off-White
Forms 
  • Slab
Processing Method 
  • Calendering
  • Compounding
  • Compression Molding
  • Extrusion
  • Resin Transfer Molding
Physical
Nominal Value
Unit
 
Mooney Viscosity 2 (ML 1+10, 250°F)
MU
 
Fluorine Content 2
%
 
Features
Features may also be described by the following terms: Good Mold Release, Easy Release, Good Demolding, Good Flow, Medium-Low Viscosity, Medium Viscosity, Low Viscosity, Medium Low Viscosity, Low Compression Set.
Uses
Uses may also be described by the following terms: Gaskets, Gasketing, Belts/Belt Repair, Belt Repair.
Available Documents
Technical Datasheet
Notes
1Typical properties: these are not to be construed as specifications.
2Raw polymer
 
UL and the UL logo are trademarks of UL LLC © 2017. All Rights Reserved.
The information presented here was acquired by UL from the producer of the product or material or original information provider. However, UL assumes no responsibility or liability for the accuracy of the information contained on this website and strongly encourages that upon final product or material selection information is validated with the manufacturer. This website provides links to other websites owned by third parties. The content of such third party sites is not within our control, and we cannot and will not take responsibility for the information or content.