4LOY® 10E17500 Datasheet

Polycarbonate + ABS

Supplied by 4Plas

Create your free Prospector account to view this complete product datasheet. A free account includes access to hundreds of thousands of detailed technical datasheets. Create Your Free Account
Product Description
4LOY 10E17500 is a MFI 14 to 16 65% PC / 35% ABS, UV Stabilised PC/ABS
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Additive 
  • UV Stabilizer
Features 
  • UV Resistant
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
ISO 1183
Water Absorption 2 (Equilibrium, 73°F, 50% RH)
%
ISO 62
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus (73°F)
psi
ISO 527-2/5
Tensile Stress (Break, 73°F)
psi
ISO 527-2/5
Tensile Strain (Break, 73°F)
%
ISO 527-2/5
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact Strength (73°F)
ft·lb/in²
ISO 180/1A
Thermal
Nominal Value
Unit
Test Method
Heat Deflection Temperature (66 psi, Unannealed)
°F
ISO 75-2/B
Vicat Softening Temperature
°F
ISO 306/B
Flammability
Nominal Value
Unit
Test Method
Flame Rating (0.06 in)
 
UL 94
Glow Wire Ignition Temperature (0.08 in)
°F
IEC 60695-2-13
Features
Features may also be described by the following terms: Good UV Resistance, UV Resistant, Ultraviolet Resistant, Ultraviolet Light Resistant.
Available Documents
Processing (English)
Technical Datasheet (English)
Injection
Nominal Value
Unit
 
Drying Temperature
°F
 
Drying Time
hr
 
Suggested Max Moisture
%
 
Processing (Melt) Temp
°F
 
Mold Temperature
°F
 
Injection Rate
 
 
Holding Pressure
psi
 
Screw Speed
rpm
 
Injection Notes
Feed Throat Temperature: 60 - 80 °C
Back Pressure: Low
Notes
1Typical properties: these are not to be construed as specifications.
224 Hrs
 
UL and the UL logo are trademarks of UL LLC © 2017. All Rights Reserved.
The information presented here was acquired by UL from the producer of the product or material or original information provider. However, UL assumes no responsibility or liability for the accuracy of the information contained on this website and strongly encourages that upon final product or material selection information is validated with the manufacturer. This website provides links to other websites owned by third parties. The content of such third party sites is not within our control, and we cannot and will not take responsibility for the information or content.