INSULCAST® 125/INSULCURE 9 Datasheet

Epoxy; Epoxide

Filler

Supplied by ITW Polymers Coatings North America

Create your free Prospector account to view this complete product datasheet. A free account includes access to hundreds of thousands of detailed technical datasheets. Create Your Free Account
Product Description
INSULCAST 125 is a low viscosity, general purpose potting and casting compound. The low viscosity enables it to be used in potting densely packed modules, thereby insuring good flow and penetration around components. INSULCAST 125 contains non-abrasive fillers and is suitable for automatic dispensing equipment.
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Filler / Reinforcement 
  • Filler
Features 
  • General Purpose
  • Good Flow
  • Low Viscosity
Uses 
  • General Purpose
Processing Method 
  • Casting
  • Potting
 
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength
psi
ASTM D638
Tensile Elongation (Break)
%
ASTM D638
Flexural Strength
psi
ASTM D790
Compressive Strength
psi
ASTM D695
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
ASTM D2240
Thermal
Nominal Value
Unit
Test Method
CLTE - Flow
in/in/°F
 
Thermal Conductivity
Btu·in/hr/ft²/°F
 
Heat Deflection Temperature
°F
 
Service Temperature
°F
 
Electrical
Nominal Value
Unit
Test Method
Volume Resistivity
ohms·cm
ASTM D257
Dielectric Strength
V/mil
ASTM D149
Dielectric Constant (1 kHz)
 
ASTM D150
Dissipation Factor (1 kHz)
 
ASTM D150
Thermoset
Nominal Value
Unit
Test Method
Thermoset Components
     
Hardener
 
 
Resin
 
 
Shelf Life (77°F)
wk
 
Features
Features may also be described by the following terms: Low Viscosity, Good Flow.
Available Documents
Technical Datasheet (English)
Uncured Properties
Nominal Value
Unit
Test Method
Color
     
-- 2
 
 
-- 3
 
 
Density
    ASTM D1475
-- 2
g/cm³
 
-- 3
g/cm³
 
Viscosity
     
-- 2
Pa·s
 
77°F 4
Pa·s
 
-- 3
Pa·s
 
Curing Time (77°F)
hr
 
Pot Life 5 (77°F)
min
 
Notes
1Typical properties: these are not to be construed as specifications.
2INSULCURE 9
3INSULCAST 125
4Mixed
5100 gram mass
 
UL and the UL logo are trademarks of UL LLC © 2017. All Rights Reserved.
The information presented here was acquired by UL from the producer of the product or material or original information provider. However, UL assumes no responsibility or liability for the accuracy of the information contained on this website and strongly encourages that upon final product or material selection information is validated with the manufacturer. This website provides links to other websites owned by third parties. The content of such third party sites is not within our control, and we cannot and will not take responsibility for the information or content.