EcoBlend® HCL7110NH Datasheet

Polylactic Acid + PMMA

Supplied by Shanghai KumhoSunny Plastics Co., Ltd.

Create your free Prospector account to view this complete product datasheet. A free account includes access to hundreds of thousands of detailed technical datasheets. Create Your Free Account
Product Description
HCL7110NH is a kind of appending 10%~20% biological base plastic environmental halogen free flame retardant PLA/PMMA resin.The flame retardant rate is 1.6mmV0.HCL7110NH is mainly used in ornament & housing of small appliance,etc.
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
Additive 
  • Flame Retardant
Features 
  • Flame Retardant
  • Halogen Free
  • Renewable Resource Content
Uses 
  • Appliances
  • Housings
 
UL File Number 
  • E65424
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density / Specific Gravity
 
ASTM D792
Melt Mass-Flow Rate (MFR) (240°C/5.0 kg)
g/10 min
ASTM D1238
Molding Shrinkage - Flow
in/in
ASTM D955
Biobased Content
%
 
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength
psi
ASTM D638
Tensile Elongation (Break)
%
ASTM D638
Flexural Modulus
psi
ASTM D790
Flexural Strength
psi
ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (0,126 in)
ft·lb/in
ASTM D256
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (264 psi, Unannealed)
°F
ASTM D648
Vicat Softening Temperature
°F
ASTM D1525 2
Electrical
Nominal Value
Unit
Test Method
Surface Resistivity
ohms
IEC 60093
Volume Resistivity
ohms·cm
IEC 60093
Flammability
Nominal Value
Unit
Test Method
Flame Rating (0,06 in)
 
UL 94
Additional Information
Nominal Value
Unit
Test Method
CSA File No.
 
 
Features
Features may also be described by the following terms: Zero Halogen Content, Halogen Free, Renewable Resources, From Renewable Resources, Renewable Resource Derived, Renewable Raw Materials, Renewable Resource Content.
Uses
Uses may also be described by the following terms: Housings, Housing.
Available Documents
Technical Datasheet (English)
Injection
Nominal Value
Unit
 
Drying Temperature
°F
 
Drying Time
hr
 
Suggested Max Moisture
%
 
Rear Temperature
°F
 
Middle Temperature
°F
 
Front Temperature
°F
 
Nozzle Temperature
°F
 
Processing (Melt) Temp
°F
 
Mold Temperature
°F
 
Back Pressure
psi
 
Screw Speed
rpm
 
Notes
1Typical properties: these are not to be construed as specifications.
2Rate B (120°C/h)
 
UL and the UL logo are trademarks of UL LLC © 2021. All Rights Reserved.
The information presented here was acquired by UL from the producer of the product or material or original information provider. However, UL assumes no responsibility or liability for the accuracy of the information contained on this website and strongly encourages that upon final product or material selection information is validated with the manufacturer. This website provides links to other websites owned by third parties. The content of such third party sites is not within our control, and we cannot and will not take responsibility for the information or content.