Bapolene® 200F Datasheet

Low Density Polyethylene

Supplied by Bamberger Polymers, Inc.

Create your free Prospector account to view this complete product datasheet. A free account includes access to hundreds of thousands of detailed technical datasheets. Create Your Free Account
Product Description
This resin is a general purpose clarity low density polyethylene for blown film extrusion applications. It contains medium levels of slip/antiblock additives. This product meets US FDA 21 CFR 177.1520.
General  
Material Status 
  • Commercial: Active
Availability 
  • Africa & Middle East
  • Asia Pacific
  • Europe
  • Latin America
  • North America
Additive 
  • Antiblock: 1300 ppm
  • Slip: 700 ppm
  
Features 
  • Food Contact Acceptable
  • General Purpose
  • Low Density
  • Medium Antiblocking
  • Medium Slip
Uses 
  • Blown Film
  • Film
  • General Purpose
Agency Ratings 
Forms 
  • Pellets
Processing Method 
  • Blown Film
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Films
Nominal Value
Unit
Test Method
Film Thickness - Tested 2
mil
  
Secant Modulus 3
     ASTM D882
1% Secant, MD
psi
  
1% Secant, TD
psi
  
Tensile Strength
     ASTM D882
MD : Break
psi
  
TD : Break
psi
  
Tensile Elongation
     ASTM D882
MD : Break
%
  
TD : Break
%
  
Dart Drop Impact
g
 ASTM D1709
Elmendorf Tear Strength
     ASTM D1922
MD
g
  
TD
g
  
Optical
Nominal Value
Unit
Test Method
Haze
%
 ASTM D1003
Features
Features may also be described by the following terms: Medium Antiblocking, Medium Antiblock, Medium Slip, Low Density, Low Specific Gravity.
Uses
Uses may also be described by the following terms: Blown Film.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Available Documents
Technical Datasheet
Notes
1Typical properties: these are not to be construed as specifications.
22:1 blow-up ratio
30.1 mm/mm-min Initial strain rate
 
UL and the UL logo are trademarks of UL LLC © 2021. All Rights Reserved.
The information presented here was acquired by UL from the producer of the product or material or original information provider. However, UL assumes no responsibility or liability for the accuracy of the information contained on this website and strongly encourages that upon final product or material selection information is validated with the manufacturer. This website provides links to other websites owned by third parties. The content of such third party sites is not within our control, and we cannot and will not take responsibility for the information or content.