Aaroprene® ATPR 1000 50A Datasheet

Thermoplastic Elastomer

Supplied by Aaron Industries Corp.

Create your free Prospector account to view this complete product datasheet. A free account includes access to hundreds of thousands of detailed technical datasheets. Create Your Free Account
Product Description
Aaroprene® ATPR 1000 50A is a Thermoplastic Elastomer (TPE) material. It is available in North America for extrusion, film extrusion, or injection molding.
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Appearance 
  • Colors Available
Forms 
  • Pellets
Processing Method 
  • Extrusion
  • Film Extrusion
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density / Specific Gravity
 
ASTM D792
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus
psi
ASTM D412
Taber Abrasion Resistance (1000 Cycles, H-18 Wheel)
mg
ASTM D1044
Elastomers
Nominal Value
Unit
Test Method
Tensile Strength (Yield)
psi
ASTM D412
Tensile Elongation (Break)
%
ASTM D412
Tear Strength 2
lbf/in
ASTM D624
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore A)
 
ASTM D2240
Available Documents
Processing (English)
Technical Datasheet (English)
Injection
Nominal Value
Unit
 
Rear Temperature
°F
 
Middle Temperature
°F
 
Front Temperature
°F
 
Nozzle Temperature
°F
 
Injection Pressure
psi
 
Injection Rate
 
 
Back Pressure
psi
 
Screw Speed
rpm
 
Injection Notes
Injection Time: 3 sec
Hold Time: 5 sec
Clamp Time: 10 sec
Cycle Time: 20 sec
Extrusion
Nominal Value
Unit
 
Cylinder Zone 1 Temp.
°F
 
Cylinder Zone 2 Temp.
°F
 
Cylinder Zone 3 Temp.
°F
 
Cylinder Zone 4 Temp.
°F
 
Cylinder Zone 5 Temp.
°F
 
Melt Temperature
°F
 
Die Temperature
°F
 
Screw L/D Ratio
 
 
Extrusion Notes
Low Compression Ratios
Deep Flighted Metering Sections
Film Extrusion Melt Temperature: 325 to 375°F
Notes
1Typical properties: these are not to be construed as specifications.
2Die C
 
UL and the UL logo are trademarks of UL LLC © 2020. All Rights Reserved.
The information presented here was acquired by UL from the producer of the product or material or original information provider. However, UL assumes no responsibility or liability for the accuracy of the information contained on this website and strongly encourages that upon final product or material selection information is validated with the manufacturer. This website provides links to other websites owned by third parties. The content of such third party sites is not within our control, and we cannot and will not take responsibility for the information or content.