Resinoid 1550 is a milled glass and mineral reinforced, two-step phenolic molding compound offering good mechanical properties. This product has been specifically formulated at a 2.47 specific gravity. This material comes in pelletized form and is suitable for injection, transfer or compression molding. It can be preformed on automatic equipment.

Resinoid 2002-4A is a fabric reinforced, two-step phenolic molding compound. It has been modified to meet gear requirements and other stressed applications. It possesses excellent impact and flexural strength. It is available in bulk form and is recommended for compression or transfer molding.

Resinoid 2005 is a cellulose reinforced, two-step phenolic molding compound. It exhibits excellent electrical and thermal properties and dimensional stability. This material comes in pelletized from and is suitable for transfer or compression molding. It can be preformed on automatic equipment.

Resinoid 2089 is a chopped fabric reinforced, two-step phenolic molding compound offering good physical and wear properties. This product has been specifically formulated for mechanical applications where minimal wear and low shrinkage values are desired. This material comes in bulk fabric form and is suitable for compression molding.

Resinoid 2215 is an organic fiber reinforced compound offering moderate impact strength. This product is available in a small pellet suitable for compression, transfer and injection molding.

Resinoid 2277 is a chopped fabric reinforced, two-step phenolic molding compound. It was specifically developed for molding applications where a lightweight, high strength material with good impact strength is needed. This material comes in pelletized from and is suitable for transfer or compression molding and can be used in injection molding systems with deep flight screws. Resinoid 2277 meets the requirements of ASTM D-5948 CFI-20 (Formerly MIL M14/1 CFI-20).

Glass-fibre reinforced phenolic moulding compound Excellent heat resistance, low mould shrinkage and post-shrinkage, good chemical resistance and very good mechanical properties Primary application(s): Parts for the automobile and engineering industries having high demands on dimensional stability This product meets the allowed upper limits for heavy metals and PCAs and also conforms to the requirements of the EU directives 2002/95 (RoHS), 2002/96 (WEEE) and 2006/122 (PFOS)

Resiten® 600 is an economical paper based phenolic mechanical material exhibiting lower electrical requirements than that requiring NEMA XX. Material usage includes drill board, backer board or as an excellent fixturing media. Advantages are reduced cost and weight compared with steel.

A coarse cotton fabric with a molybdenum disulfide/ phenolic resin system that was developed as an alternative to graphite/phenolic laminates.