CLEAR COTE™ UV Stable Crystal Clear, Table Top Epoxy System is a high performance two component clear epoxy system designed for table tops, bars, wood finishes, see-through encapsulations, art work, and other applications requiring a clear, strong, plastic coating specifically designed to resist yellowing caused by the sun and other Ultra Violet light sources. The material has an easy to use 1 to 1 by volume mix ratio, wets out substrates well, maintains its integrity over sharp corners, it has excellent air release qualities, and a relatively fast set time for an epoxy coating which may be accelerated by mild heat to 160F. While this material will do much better then competitors products for non yellowing we still do not recommend it for permanent outdoor applications. Advantages: - 100% Solids - Self Leveling, High Gloss - U.V. Resistant Formula - Excellent Air Release - Excellent Color Stability - Improved Impact Strength - Improved Surface Appearance - Early Development of Physical and Performance Properties - Produces a Tough, High Gloss, Water Resistant Coating - Eliminates Craters, Crawling and Fish Eyes - Blush Resistant

Clear Cote™ Table Top Epoxy System is a high quality, two component, clear, epoxy coating system designed for table tops, bars, wood finishes, art work, see-through encapsulations and other applications requiring a clear, strong, plastic coating.

TECHNO-COTE™ by CLEAR COTE™ is a 3 Speed (2 to 1, by volume/weight ) high quality, laminating system. It is 100% Epoxy solids. It is designed for the rapid wet out of fiberglass, Kevlar, carbon fiber and other composite materials. This system can be purchased with any one of 3 different Activators depending up on the desired cure speed and pot life. The material has an easy to use 2 to 1 mix ratio (2 Parts resin to 1 Part Activator, by volume/weight ) that cures at room temperature with little to no blush to a tough, rigid, impact resistant plastic, with excellent resistance to water, chemicals, and solvents. This material is suitable for use in mechanical volume pumps, always mix these materials thoroughly and be sure to scrape the sides and bottom. As with all adhesive type compounds proper surface preparation is essential for good bond strength, additionally recoating of this material should be accomplished before the material is thoroughly cured generally in less then 24 hours. If the material has cured hard and tack free, a sanding and solvent wash will be necessary before recoating.